the path to it and its name should also not contain spaces and Russian characters.
Dyna mptool iso#
Preparing the ISO image that we want to burn. We unpack the program into a folder with any name, but this the folder must be in the root of the disk, the path to it and its name must not contain spaces and Russian characters: If the readings are different, then you will need other tools for the firmware and this article is not for you.Īmong other things, the screen shows that there is no mention of Silicon Power, which suggests that the flash, most likely died from inept interference, i.e. If USB Device ID: VID = 090C PID = 1000 (maybe PID = 3000), and Chip Part-Number: SM3257ENAA, So this is exactly the flash drive in question. The fields marked with red arrows are important to us. In this case, it doesn't matter, at the same time we will restore it. In my case, the flash drive was sick, and when I tried to open the message appeared: Insert the disk into the device "Removable Disk. We are waiting for it to be determined by the system. We insert the USB flash drive into the rear USB connector without any adapters, extension cords, splitters, etc.
Dyna mptool download#
To do this, download and unpack the program, you can on the desktop. The flash drive, which we will mock, looks like this:īut that doesn't mean anything yet. preparation of the program and ISO image.
Dyna mptool windows 7#
Computer with Windows 7 (XP) on board with admin rightsĬreating a CD-ROM partition on a Silicon Power Ultima II I Series 32Gb flash drive.Flash recovery utility for Silicon Motion SM3257 controllers.A utility for obtaining information about all connected USB devices.So everything is done at your own peril and risk and is applicable only to the described model. Visit the FLASHBOOT.RU website, especially its forum and read it, if only in order to understand that everything that we will do does not give us any guarantee of success. Not for every flash drive you can find such a program. Each flash drive, depending on the manufacturer, model and series, needs its own program, since the controllers are different everywhere. This is dangerous, as a ridiculous mistake can kill her. To create a CD-ROM partition on a USB flash drive requires intervention at the controller level of the flash drive. In general, there are many advantages, but there are also disadvantages: Minuses: The CD section is inaccessible for writing, therefore it is protected from viruses.
Distributions do not need to be modified, only an ISO image is needed. In BIOS, it is defined as a physical drive connected to USB port. In the system, such a partition will be identified as a CD / DVD drive into which the corresponding disc was inserted. Pros.ĬD-ROM section on USB flash drive will get rid of these difficulties. And many conscientious viruses will replace it with their own or add their entries to it. AUTORUN disk with software, you can simply copy to USB stick, but many unscrupulous antiviruses will destroy the autorun.inf file and everything connected with it. Linux distributions can usually be burned using special programs that are often included with LIVE CDs. Installing Windows 7 from a USB drive is a little easier - no need to tinker with the distribution kit, just prepare bootable USB drive. For example, Windows installation XP with USB Flash the disk is fraught with some difficulties: It is necessary to make the Flash disk bootable, write to it Boot bootloader, work with Windows distribution XP to complete the installation. But not always the distribution kit can be simply taken and written to a USB flash drive. It is more convenient to use flash drives. Many computers today do not come with floppy drives.